Brake Inspection In this manual: Brake General — 26Audio, Visual, Telematics — 333Brake — 176Engine, Hybrid System — 816Power Source, Network — 88Steering — 88Vehicle Interior — 1071 ~1min read INSPECTION PROCEDURE 1. INSPECT VSC OFF SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard resistance: Tester Connection Switch Condition Specified Condition 6 - 9 Pressed Below 1 Ω Not pressed 10 kΩ or higher If the result is not as specified, replace the VSC OFF switch. ← Previous Components Next → Installation Was this page helpful?👍 Yes👎 No