Vehicle Interior
Installation
In this manual: Vehicle Interior
~1min read
INSTALLATION
PROCEDURE
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Install the curtain shield airbag with the 10 bolts.
Torque:
11 N·m {110 kgf·cm, 8 ft·lbf}
NOTICE:
Do not twist the curtain shield airbag when installing it.
(b) Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL ROOF HEADLINING ASSEMBLY
(a) Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (for CrewMax) (see page
)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
).
4. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (see page
).
Was this page helpful?