Installation
INSTALLATION
PROCEDURE
1. INSTALL TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY)
(a) Connect the 2 connectors to the trailer brake control ECU (brake control with bracket relay).
(b) install the trailer brake control ECU (brake control with bracket relay) with the 2 nuts.
Torque:
7,5 N·m {76 kgf·cm, 66 in·lbf}
2. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
3. INSTALL LOWER INSTRUMENT PANEL
Click here ![]()
4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here ![]()
5. INSTALL INSTRUMENT SIDE PANEL RH
Click here ![]()
6. INSTALL COWL SIDE TRIM BOARD RH
Click here
![]()
7. INSTALL FRONT DOOR SCUFF PLATE RH
Click here
![]()
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here ![]()
9. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here ![]()
10. CHECK SRS WARNING LIGHT
Click here ![]()