Tightening torque found on this page
INSTALLATION
PROCEDURE
1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY
(a) Install the control pedal to the body with the 3 nuts.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf} |
 |
(b) Attach the wire harness clamp to the control pedal. |
 |
(c) Connect the parking brake switch connector.
2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Connect the parking brake cable to the control pedal. |
 |
(b) Using needle-nose pliers, slowly bend down the claw.
NOTICE:
Be careful not to damage the parking brake cable or claw.
(c) Install the clip to the control pedal. |
 |
(d) Temporarily install the adjustment nut and lock nut.
HINT:
The nuts will be tightened to a torque specification in the "ADJUST PARKING BRAKE PEDAL TRAVEL" procedure. |
 |
3. CHECK PARKING BRAKE PEDAL TRAVEL
4. ADJUST PARKING BRAKE PEDAL TRAVEL
5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(See page )
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
Was this page helpful?