Brake
Rear Brake Flexible Hose
Tightening torque found on this page
ComponentsCOMPONENTS
ILLUSTRATION
InstallationINSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
PROCEDURE
1. INSTALL REAR BRAKE FLEXIBLE HOSE
(a) Install the flexible hose and a new gasket to the disc brake cylinder with the new union bolt.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
HINT:
Install the flexible hose lock securely in the lock hole in the cylinder. |
 |
(b) Set the flexible hose to the connecting point with the brake tube, and then attach a new clip.
(c) Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.
Torque:
15 N·m {155 kgf·cm, 11 ft·lbf}
NOTICE:
- Do not bend or damage the brake tube.
- Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
- Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page
).
|
 |
2. BLEED BRAKE LINE
3. INSTALL REAR WHEEL
Torque:
for Aluminum Wheel :
131 N·m {1336 kgf·cm, 97 ft·lbf}
for Steel Wheel :
209 N·m {2131 kgf·cm, 154 ft·lbf}
RemovalREMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.
3. REMOVE REAR BRAKE FLEXIBLE HOSE
(a) Disconnect the brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.
NOTICE:
- Do not bend or damage the brake tube.
- Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
|
 |
(b) Remove the clip.
(c) Remove the union bolt and gasket, and then remove the flexible hose from the disc brake cylinder. |
 |
|
Was this page helpful?