Removal
REMOVALHINT:
PROCEDURE1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH (a) Remove the front axle hub (see page 2. DISCONNECT FRONT SPEED SENSOR LH
(b) Disconnect the speed sensor from the steering knuckle. 3. DISCONNECT TIE ROD END SUB-ASSEMBLY LH (a) Remove the cotter pin and nut.
4. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH 5. REMOVE STEERING KNUCKLE LH (a) Support the front suspension lower arm LH with a jack. (b) Remove the clip and the nut.
(d) Remove the steering knuckle. 6. REMOVE KNUCKLE GREASE RETAINER CAP LH (for 2WD)
7. REMOVE STEERING KNUCKLE OIL SEAL LH (for 4WD)
|





