Engine, Hybrid System

Removal

~1min read
1special tools

REMOVAL

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE FRONT WHEEL

2. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH

(a) Remove the front shock absorber with coil spring (see page ).

3. DISCONNECT SKID CONTROL SENSOR WIRE

(a) Remove the 2 bolts and disconnect the sensor wire from the steering knuckle and suspension upper arm.

4. DISCONNECT STEERING KNUCKLE LH

(a) Support the front suspension lower arm LH with a jack.

(b) Remove the clip and the nut.

(c) Using SST, disconnect the upper ball joint from the steering knuckle.

SST: 09628-62011

5. REMOVE FRONT FENDER APRON SEAL LH

(a) Using a clip remover, remove the 6 clips and apron seal.

6. REMOVE FRONT FENDER APRON SEAL REAR LH

(a) Using a clip remover, remove the 5 clips and apron seal.

7. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY

(a) Remove the nut, bolt, 2 washers and suspension upper arm.