DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply excessive force to the W9 forward recognition camera connector.
CHECK FORWARD RECOGNITION CAMERA
(a) Disconnect the forward recognition camera connector.
*a
Front view of wire harness connector
(to Forward Recognition Camera)
-
-
(b) Measure the voltage and resistance according to the value(s) in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
W9-7 (IGB) - W9-10 (GND)
R - W-B
Power source
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
W9-10 (GND) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
(c) Reconnect the forward recognition camera connector.
*a
Component with harness connected
(Forward Recognition Camera)
-
-
(d) Measure the voltage according to the value(s) in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
W9-1 (HTR) - W9-10 (GND)
V - W-B
Camera heater (forward recognition hood) operation signal
Ignition switch ON, camera heater (forward recognition hood) not operating
11 to 14 V
Ignition switch ON, camera heater (forward recognition hood) operating
0 to 1.5 V
W9-8 (BZ) - W9-10 (GND)
SB - W-B
Skid control buzzer assembly
Ignition switch ON, skid control buzzer assembly not operating
11 to 14 V
Ignition switch ON, skid control buzzer assembly operating
0 to 1.5 V
(e) Check for pulses according to the value(s) in the table below.
HINT:
If the waveform is not similar to that shown in the illustration, a malfunction of a CAN bus line, terminating resistor, or the forward recognition camera is suspected.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
W9-5 (CA1P) - W9-10 (GND)
BE - W-B
CAN communication signal
Ignition switch ON
Pulse generation
(See waveform 1)
W9-11 (CA1N) - W9-10 (GND)
W - W-B
CAN communication signal
Ignition switch ON
Pulse generation
(See waveform 2)
W9-6 (CANH) - W9-10 (GND)
G - W-B
CAN communication signal
Ignition switch ON
Pulse generation
(See waveform 1)
W9-12 (CANL) - W9-10 (GND)
W - W-B
CAN communication signal
Ignition switch ON
Pulse generation
(See waveform 2)
(1) Waveform 1
Item
Content
Terminal Name
Between W9-5 (CA1P) and W9-10 (GND)
Between W9-6 (CANH) and W9-10 (GND)
Tester Range
1 V/DIV., 10 μsec./DIV.
Condition
Ignition switch ON
HINT:
The waveform varies depending on the CAN communication signal.
(2) Waveform 2
Item
Content
Terminal Name
Between W9-11 (CA1N) and W9-10 (GND)
Between W9-12 (CANL) and W9-10 (GND)
Tester Range
1 V/DIV., 10 μsec./DIV.
Condition
Ignition switch ON
HINT:
The waveform varies depending on the CAN communication signal.