Toyota Venza Quiz
Supplemental Restraint Systems

Inspection

In this manual: Supplemental Restraint Systems
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~2min read
INSPECTION PROCEDURE

1. INSPECT SPIRAL CABLE

(a) Visually check for defects with the spiral cable removed from the vehicle.

(1) The defects are as follows:

  • Scratches on the spiral cable
  • Small cracks the spiral cable
  • Dents on the spiral cable
  • Chips on the spiral cable
  • Cracks or other damage to the connector

    OK:

    No defects are found.

HINT:

If any of the defects is found, replace the spiral cable with a new one.

(b) Inspect the spiral cable.

Text in Illustration

*1

Component without harness connected

(Spiral Cable)

*2

Color: Orange

*3

Color: Black

(1) Measure the resistance according to the value(s) in the table below.

NOTICE:

To avoid breakage of the spiral cable, do not turn the spiral cable more than necessary.

If the value is not within the specified range, replace the spiral cable.

Standard Resistance

Tester Connection

Condition

Specified Condition

z5-1 - D18-8 (HO)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z5-3 - D18-10 (-DP)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z5-5 - D18-12 (IL+2)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z5-7 - D18-3 (EAU)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z5-8 - D18-4 (AU3)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z5-9 - D18-5 (AU2)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z5-10 - D18-6 (AU1)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z6-3 - D18-1 (CCS)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z6-4 - D18-2 (ECC)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z1-1 - D7-2 (D-)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z1-2 - D7-1 (D+)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z2-1 - D7-3 (D2-)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

z2-2 - D7-4 (D2+)

Center

Below 1 Ω

2.5 rotations to the left

2.5 rotations to the right

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.