Toyota Venza Quiz
Parking Brake

Removal

In this manual: Parking Brake
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL PROCEDURE

1. REMOVE PARKING BRAKE PEDAL ASSEMBLY

HINT:

Refer to the instructions for Removal of the parking brake pedal assembly (See page ).


2. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the clip.

(b) Depress the parking brake pedal.

(c) Pull up the parking brake pedal claw and remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.

3. REMOVE REAR WHEEL

4. REMOVE NO. 4 PARKING BRAKE CABLE ASSEMBLY

(a) Slide the rubber boot as shown in the illustration.

(b) Separate the No. 4 parking brake cable assembly from the parking brake equalizer as shown in the illustration.

(c) Remove the 2 bolts and No. 4 parking brake cable assembly.

5. REMOVE PARKING BRAKE EQUALIZER

(a) Move the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly as shown in the illustration to remove the parking brake equalizer.

6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER

HINT:

Refer to the instructions for Removal of the No. 2 parking brake shoe assembly with parking brake shoe lever (See page ).


7. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 2 bolts and separate the No. 3 parking brake cable assembly from the backing plate.

(b) Remove the bolt, 4 nuts and the No. 3 parking brake cable assembly.


8. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT:

Use the same procedure as for the No. 3 parking brake cable assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.