Toyota Venza: Removal

REMOVAL PROCEDURE

1. REMOVE YAW RATE AND ACCELERATION SENSOR

HINT:

Refer to the instructions for Removal of the yaw rate and acceleration sensor (See page ).

2. REMOVE REAR NO. 2 AIR DUCT

3. REMOVE REAR NO. 1 AIR DUCT

4. REMOVE FRONT NO. 2 FLOOR SILENCER

(a) Remove the front No. 2 floor silencer.

5. LOOSEN PARKING BRAKE

(a) Remove the lock nut and No. 1 wire adjusting nut to completely loosen the parking brake.

Text in Illustration

*1	No. 1 wire adjusting nut
*2	Lock nut

6. DISCONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY

(a) Holding the lock nut of the No. 1 parking brake cable assembly, loosen the turnbuckle of the No. 4 parking brake cable assembly to disconnect the No. 4 parking brake cable assembly from the No. 1 parking brake cable assembly.

Text in Illustration

*1	Hold
*2	Turn

7. REMOVE PARKING BRAKE PEDAL ASSEMBLY

(a) Disconnect the heated oxygen sensor connector and disengage the 2 clamps (for 2GR-FE).

(b) Disconnect the 2 connectors.

(d) Remove the nut and 4 bolts, and separate the No. 1 parking brake cable assembly from the body.

(e) Disconnect the parking brake switch connector.

(f) Remove the 3 nuts and parking brake pedal assembly.

Removal

Test yourself