Toyota Venza Quiz
Exterior Panels / Trim

Rocker Panel Moulding

In this manual: Exterior Panels / Trim
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE FRONT FENDER OUTSIDE MOULDING


2. REMOVE NO. 2 ROCKER PANEL MOULDING PROTECTOR


3. REMOVE REAR ROCKER PANEL MOULDING END COVER


4. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY

(a) Put protective tape around the body rocker panel moulding assembly.

Text in Illustration

*1

Protective Tape

(b) Remove the screw.

(c) Remove the grommet.

(d) Remove the 7 clips.

(e) Disengage the 7 clips to remove the body rocker panel moulding assembly.

(f) Remove the 7 clips (rocker panel moulding clip).

Installation INSTALLATION PROCEDURE

1. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY

(a) Install 7 new clips (rocker panel moulding clip) to the body rocker panel moulding assembly.

(b) Engage the 7 clips to install the body rocker panel moulding assembly.

(c) Install the screw.

(d) Install the grommet.

(e) Install the 7 clips.

2. INSTALL REAR ROCKER PANEL MOULDING END COVER


3. INSTALL NO. 2 ROCKER PANEL MOULDING PROTECTOR


4. INSTALL FRONT FENDER OUTSIDE MOULDING

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.