Installing brackets for parking aid system

Note Observe manufacturer's instructions enclosed in the packaging. Observe minimum curing period. Installing brackets

The brackets are installed after the bumper cover has been painted.

The 4 markings for brackets -1- can be found on the inside of the bumper cover.

• If there are no markings, the centre point -2- must be determined.
• The holes must be drilled from the inside to the outside with the drill in the tool kit -3-.

• Set hole punch in position with bolt head -1-, washer -2- and thrust bearing -3- from inside bumper cover -5-.
• Screw on punch -4-, not quite as far as bumper cover.
• Press punch -4- against bumper cover.
• Tighten hole punch -1-.

The punch -4- must not turn on the paint of the bumper cover.

• Pull the punch -4- through the material of the bumper cover -5--arrows- by turning the bolt head -1-.
• Remove hole punch and make the next holes.
• Thoroughly clean bumper cover and bracket with cleaning solution.

Approx. 1 cm of adhesive from tip should not be applied.

• Lightly sand inside of bumper cover -6- and clean thoroughly.
• Apply a very thin layer of bonding agent for plastics to bumper cover and bracket and allow to flash off for 10 minutes.
• Push bracket -8- onto centring pin -1- and through bumper cover -6-.
• Push counterhold -4- on and gently tighten knurled nut -5-.
• Push clip -3- on and then place knurled nut -2- in position but do not tighten it.
• All the brackets are prepared to this stage.

The adhesive must not run into the angle.

• Apply adhesive as shown in illustration and tighten knurled nut -2-.
• Remove all centring pins after minimum curing period.