Volkswagen Golf Quiz
Running gear, axles, steering

Removing and installing anti-roll bar

In this manual: Running gear, axles, steering
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Special tools and workshop equipment required

Torque wrench -V.A.G 1331-

Removing

  • Loosen wheel bolts.
  • Raise vehicle.
  • Remove rear wheels.
Note The following procedure is described for the left side of the vehicle. The procedure for the right side of the vehicle is identical.
Removing and installing anti-roll bar
  • Unscrew bolts -arrows- for anti-roll bar -1-.
Removing and installing anti-roll bar
  • Unscrew nut -1- from coupling rod -2-.
  • Pull coupling rod -2- out of anti-roll bar -3-.
  • Remove anti-roll bar -3- from subframe.

Installing

Install in reverse order of removal, observing the following:
Removing and installing anti-roll bar
  • Tighten bolts -arrows- for anti-roll bar -1- evenly on subframe -2-.

Specified torques

→ Chapter „Assembly overview - anti-roll bar“

→ Chapter „Torque settings for wheel bolts“
Removing and installing anti-roll bar

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.