Volkswagen Golf Quiz
Electrical system, general information

Renewing LSU Lambda probe (6-pin)

In this manual: Electrical system, general information
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
Note If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified. The wires should not be crimped or cut as otherwise the function of the Lambda probe will be impaired.
  • Remove the old Lambda probe.
  • Place both Lambda probes next to each other so that the sensor housings are at the same height.
Renewing LSU Lambda probe (6-pin)
  • Tie back any excess in the uniform probe length (approx. 50 - 250 mm) to the size of the defective probe and secure with cable ties -1-.
  • Install the new Lambda probe in the vehicle.
Renewing LSU Lambda probe (6-pin)

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.