Retrofitting two-way radios

First read and observe the introductory information and safety warnings

You will need an external aerial to use a two-way radio in the vehicle.

Any retrofit installation of electrical or electronic equipment in the vehicle will affect its vehicle type approval. Under certain circumstances, this can negate the type approval for the vehicle.

Volkswagen has approved the vehicle for use with two-way radios subject to the following conditions:

• Correct installation of external aerial.

• A maximum transmitting power of 10 watts.

The equipment can only operate at maximum range with an external aerial.

Check first with a qualified workshop if you wish to use a two-way radio with a transmitting power of over 10 watts. A qualified workshop is familiar with the technical options for retrofitting. Volkswagen recommends using a Volkswagen dealership for this purpose.

Please comply with relevant legislation and the instructions and information given in the operating manuals for radio equipment.

If radio equipment is not secured or not properly secured in the vehicle, it could be flung though the interior during a sudden driving or braking manoeuvre, or in the event of an accident. This can cause injuries.

• While the vehicle is in motion, always secure two-way radios properly outside the airbag deployment zones or stow them away safely.

If you use two-way radios in the car without an external aerial, electromagnetic radiation in the vehicle could exceed limit values. This also applies to external aerials which have not been correctly installed.

• Two-way radios should only be used in the vehicle if an external aerial is properly connected.