Volkswagen Polo Quiz
General Paint Information

Blender

In this manual: General Paint Information
General Paint Information — 128Towing Guide — 10Whels, Tires, Whel Alignment — 126Battery, Starter, Generator, Cruise Control — 65Windshield Wiper/ Washer System — 9Exterior Lights, Switches — 1Interior Lights, Switches — 7Wiring — 51Refrrigerant R134a Servicing — 134
~2min read

Definition:

Blender -LVE 013 100 A2-

Edition 10/2012

Product Description

Blender was developed for hassle-free two-part clear coat and top coat touch-up.

Properties:

Easy to use (pure)

Applies well to all base surfaces

Blends well with the old paint

Application Instructions

Preparation

Applying base paint:

Keep the filler surface as small as possible.

Paint filler spot thoroughly with water-based base paint (overlapping spray applications)

Touch-Up System for Two-Part Clear Lacquers

Mixing ratio for two-part clear coat:

Adjust the two-part clear coat according to technical application information. Refer to → Chapter „Clear Coats“.
Blender

Painting:

  • Paint over the water-based base paint with adjusted clear coat (overlapping spray applications).
Blender

Touch-up process:

  • Apply pure Blender -LVE 013 100 A2- onto the touch-up area inside the sanded surface.
Blender

Touch-Up System for Two-Part Top Coats

Mixing ratio for two-part top coat:

Adjust the two-part top coat according to technical application information. Refer to → Chapter „Top Coats“.
Blender

Painting:

  • Paint over filler area thoroughly (overlapping spray applications).
Blender

Touch-up process:

  • Apply pure Blender -LVE 013 100 A2- onto the touch-up area inside the sanded surface.
Blender

Polishing the Touch-Up Zones

Air dry at +20 °C room temperature:

Polish the touch-up areas after they have dried overnight
Blender

Final drying time with forced drying is a minimum of 5 to 10 minutes.
Blender

Forced drying is at +60 °C object temperature for 30 minutes.

  • After that, allow the touch-up areas to cool off for an hour and polish at +20 °C room temperature.
Blender

Final drying time for IR drying is a minimum of 5 to 10 minutes.
Blender

IR dry with a short-wave radiator for 10 minutes

  • After that, allow the touch-up areas to cool off for an hour and polish at +20 °C room temperature.
Note Polish the touch-up area with fine polishing paste by hand or with a polishing machine.

To finish, treat the surface with high-gloss sealant.
Blender

Personal Protective Equipment:

Note the safety data sheets

Wear the personal protective equipment during application

Characteristics
Blender
Flashpoint: +20 °C

Storage

The guaranteed shelf life of 60 months from date of manufacture. Use no later than the date indicated on the label and store in original container at +20 °C.
Blender

Test yourself

A quick Volkswagen Polo quiz: every answer comes with an explanation and a link to the manual page.