Component Location Overview - Heating

Component Location Overview - in Front Vehicle Interior

1. 1
   Instrument Panel
2. 2
   Center Vent

   • Vent, Removing.
3. 3
   Front Passenger Vent

   • Vent, Removing.
4. 4
   Heating and Ventilation Controls

   • With Fresh Air/Recirculation Door Switch -E159-
   • Also with Immediate Heating Button -E537- in vehicles with auxiliary heater
   • Removing the controls.
   • On vehicles with seat heating also with Heated Driver Seat Adjuster -E94- and Heated Front Passenger Seat Adjuster -E95-
5. 5
   Fresh/Recirculated Air Door Motor -V154-

   • Removing.
6. 6
   Right Footwell Vent

   • Removing and installing.
7. 7
   Fresh Air Blower -V2-

   • Removing.
8. 8
   Fresh Air Blower Series Resistor with Fuse -N24-

   • Removing and installing.
9. 9
   Partition from Heater

   • Removing.
10. 10
    Closure Caps

    • Only in vehicles without air duct to vent installed in center console at rear
11. 11
    Air Routing

    • To remove, the center console must be removed first.
12. 12
    Dust and Pollen Filter

    • With EVAP canister
    • Removing and installing.
13. 13
    Connection

    • For the center console air duct
    • To remove, the center console must be removed first.
14. 14
    Air Outlet Grille

    • Depending on vehicle equipment
15. 15
    Right Footwell Rear Channel

    • Removing and installing.
16. 16
    Left Footwell Rear Channel

    • Removing and installing.
17. 17
    Screw

    • Quantity: 8
18. 18
    Adapter for Controls
19. 19
    Heater Core

    • Replace all the coolant after replacing the heater core.
    • Removing and installing.
20. 20
    Left Footwell Vent

    • Removing and installing.
21. 21
    Temperature Control Door Release Cable

    • Removing and installing.
22. 22
    Flexible Shaft

    • Removing and installing.
23. 23
    Heater

    • Removing and installing.
    • Disassembling and Assembling.

Installation Position of Seal for Heater and Engine Compartment

• First insert the seal between the heater and engine compartment -A- into the plenum chamber bulkhead and then place on the heater core.

Note

The installation position must be observed to prevent water from entering the vehicle interior.