Wheel and Tire Guide Information

Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing

~1min read
0102030405043N·mlb·ft
Tightening torque found on this page

Overview, Beru System

WARNING If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.
WARNING

Damaged wheel electronics must be replaced.

Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing
Push the wheel electronics -1- into the bed.
Install on the valve from the back with a microencapsulated screw -item 8- → Item
Note

Replace the microencapsulated screw.

Tighten the microencapsulated screw to 4 N·m on all models.

Special tools and workshop equipment required

Torque Wrench 1410 -VAG1410- and Torque Wrench 1410 Insert - Accessory Kit -VAG1410/1-

Tightening Specifications. Refer to → Anchor.

Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing

Test yourself

A quick Volkswagen Touran quiz: every answer comes with an explanation and a link to the manual page.