Before driving

Turn signal and high beam lever

4steps
~24min
2/5difficulty
Done 0 of 4
Fig. 61

Turn signal and high beam lever in
basic position.

Read and observe the introductory information
and safety warnings first
⇒Introduction
to the topic

Move the lever to the desired position:

  1. Turn right ⇒.
    With the ignition switched off, from the center position for parking lights right ⇒ Parking lights .1)
  2. Turn left ⇒.
    With the ignition switched off, from the center position for parking lights left ⇒ Parking lights .1)
  3. High beam on ⇒.
    When the high beam is switched on, the indicator lightin the instrument cluster lights up.
  4. Operate the headlight flash or switch off the high beam.
    The headlight flash remains on as long as the lever is pulled. The indicator light lights up.

Return the lever to its neutral position to switch off the respective function.

Comfort turn signal

For comfort turn signal, move the lever up or down only to the pressure point and release it. The turn signal flashes 3 times.

To end the comfort turn signal early, immediately move the lever once to the pressure point in the opposite direction and release it. The turn signal flashes once in the opposite direction. If the lever is immediately moved twice to the pressure point in the opposite direction, the comfort turn signal is activated in the opposite direction.

The comfort turn signal can be deactivated by an authorized workshop.

Warning
Improper use of the turn signals, failing to use them, or failing to switch them off again can mislead other road users. This can cause accidents and serious injuries.
  • Always signal lane changes, overtaking and turning maneuvers in good time using the turn signal.
  • After completing a lane change, overtaking or turning maneuver, switch off the turn signal.
Warning
Improper use of the high beam can cause accidents and serious injuries, as the high beam can distract and dazzle other road users.

The turn signal only works when the ignition is switched on. The hazard warning lights also work when the ignition is switched off ⇒ In an emergency .

If a turn signal bulb fails on the vehicle, the indicator light flashes about twice as fast.

The high beam can only be switched on when the low beam is switched on.

If the audible signal does not sound when the turn signal is on, visit a specialist workshop.

1) Depends on vehicle equipment.