Care, Cleaning, Maintenance

Checklist

~4min read

    Carry out the steps in the specified order ⇒ :


  • Park the vehicle on a
    level surface with the engine at operating temperature to avoid reading an incorrect engine oil level.

  • Switch off the engine and wait a few minutes
    so that the engine oil can flow back into the oil pan.

  • Open the engine compartment lid. Preparations for
    working in the engine compartment.

  • Identify the engine oil filler cap and oil dipstick.
    The engine oil filler cap is marked with the symbol on the cap, and the oil dipstick has a colored handle. If you are not sure where the cap and dipstick are, consult a workshop.

  • Pull the oil dipstick out of the guide tube
    and wipe it with a clean cloth.

  • Push the oil dipstick back into the guide tube as far
    as it will go. If there is a marking at the top of the dipstick, this marking must align with the corresponding groove at the upper end of the guide tube when inserted.

    • Pull the oil dipstick out again and read the engine oil level on the dipstick as follows: Ⓐ Do not add engine oil. Continue with step 16. Ⓑ Engine oil level OK. Engine oil can be added up to the upper limit of this range, e.g. under high engine load or oil consumption. Continue with step 8 or 16. Ⓒ Engine oil level too low. Add engine oil without fail. Continue with step 8.
  • After reading the engine oil level, push the oil dipstick
    back into the guide tube as far as it will go.

  • Unscrew the engine oil filler cap
    .

  • Add only the engine oil expressly approved by Volkswagen for
    this engine, gradually in small quantities (no more than 0.5 l).

  • To avoid overfilling, wait about one minute after
    each addition so that the engine oil can flow into the oil pan up to the mark on the engine oil dipstick.

  • Read the engine oil level on the dipstick again
    before adding another small quantity of engine oil. Never add too much engine oil.

  • At the end of the filling process, the engine oil level should be
    in the middle of range Ⓑ. It should not be above Ⓑ, in range Ⓐ, and must not be in the area above Ⓐ.

  • If too much engine oil has been added by mistake
    and the engine oil level is then above range Ⓐ, do not start the engine. Notify a workshop and seek expert help if necessary.

  • After topping up, close the engine oil filler opening
    with the cap.

  • Push the oil dipstick as far as it will go into the guide tube
    . If there is a marking at the top of the dipstick, this marking must align with the corresponding groove at the upper end of the guide tube when inserted.

  • Close the engine compartment lid. Finishing work
    in the engine compartment.

Warning
Engine oil can ignite if it gets onto hot engine parts. This can cause fires, burns and other serious injuries.
  • If engine oil is spilled onto cold engine parts, it can heat up and ignite while the engine is running.
  • Always make sure the engine oil filler cap is screwed on tightly after topping up and that the oil dipstick is properly reinserted into the guide tube. This prevents engine oil from leaking onto hot engine parts while the engine is running.
Note
  • If too much engine oil has been added by mistake and the engine oil level is then above range ⇒ Fig. 120 Ⓐ, do not start the engine. Notify a workshop and seek expert help if necessary. Otherwise the catalytic converter and engine may be damaged!
  • When topping up operating fluids, make sure the correct operating fluids go into the correct filler openings. Using the wrong operating fluids can result in serious malfunctions and engine damage.

The engine oil level must not be above range
⇒ Fig. 120 Ⓐ. Otherwise oil may be drawn in through the crankcase breather and pass through the exhaust system into the atmosphere.

Engine oil consumptionRead and observe the introductory information
and safety warnings first
⇒Introduction
to the topic

Engine oil consumption can vary from engine to engine and may change over the service life of the engine.

Depending on driving style and operating conditions, engine oil consumption can be up to 1 l per 2000 km. In new vehicles, it may be higher during the first 5000 kilometers. For this reason, the engine oil level must be checked at regular intervals – ideally every time you refuel and before long journeys.

Under particular engine load, the engine oil level should be in the upper permissible range ⇒ Fig. 120 Ⓑ, for example during long motorway journeys in summer or when driving over mountain passes at high altitude.