While driving

Operating the cruise control system (CCS)

~2min read
Fig. 105

Turn signal and high beam lever on the left
of the steering column: CCS buttons and switch.

Read and observe the introductory information
and safety warnings first
⇒Introduction
to the topic

Function Switch position, switch operation ⇒ Fig. 105 Action
Switch on the CCS. Set switch ② to position.The system is switched on. After switching on, no speed is stored and no control takes place yet.
Activate CCS control. Button ③
Press.
The current speed is stored and maintained.
Temporarily deactivate CCS control. Set switch ② to position
OR: Press the brake or clutch pedal.
Control is temporarily deactivated. The stored speed remains saved.
Resume CCS control. Button ①
Press.
The stored speed is resumed and maintained.
Increase the stored speed (during CCS control). Button ①Briefly
press to increase the speed in small steps of 1 km/h and store it.
The vehicle accelerates actively until the newly stored speed is reached.
Button ①Press and hold
to continuously increase and store the speed until released.
Reduce the stored speed (during CCS control). Button ③Briefly
press to reduce the stored speed in small steps of 1 km/h and store it.
The speed is reduced by releasing the accelerator, without brake intervention, until the newly stored speed is reached.
Button ③Press and hold
to continuously reduce and store the speed until released.
Switch off the CCS. Set switch ② to position.The system is switched off. The stored speed is erased.

The values in brackets in mph in the table apply only to instrument clusters with mile displays.

Driving downhill with the CCS

If the CCS cannot keep the vehicle speed constant when driving downhill, brake the vehicle with the foot brake and downshift if necessary.

Automatic deactivation

CCS control is switched off automatically or temporarily interrupted:

  • If the system detects a fault that could impair the function of the CCS.
  • If the accelerator pedal is used to drive faster than the stored speed for an extended period.
  • If the brake pedal or clutch pedal is pressed.
  • If the gear is changed in a manual transmission.
  • If the selector lever of the automated manual transmission is moved out of position D/M.
  • If the airbag deploys.
  • If the vehicle was braked by the City Emergency Braking function ⇒ City Emergency Braking function.

If the CCS was switched on when the ignition was switched off, the CCS is automatically switched on again when the ignition is next switched on. However, no speed is stored.