Before driving

Attaching the base rack or crossbars and the carrier system

~2min read
Fig. 78

Attachment points for base racks
(both sides): on 2-door vehicles, : on 4-door vehicles.

Fig. 79

Attachment points for crossbars
on vehicles with roof rails (both sides).

Read and observe the introductory information
and safety warnings first
⇒Introduction
to the topic

The base racks serve as the basis for special carrier systems. For safety reasons, separate carrier systems are required for transporting luggage, bicycles, surfboards, skis and boats. Suitable accessories are available from a Volkswagen Partner.

The base rack and carrier system must always be attached correctly. The supplied installation instructions for the carrier system must be observed at all times.

Vehicles without roof rails: attaching the base rack and carrier system

2-door vehicles: The holes or markings for the attachment points of the front base racks are located on the underside of the roof side rails ⇒ Fig. 78(left magnifier). The holes or markings
of the attachment points are only visible with the door open. The markings for attaching the rear base racks are located on top of the side windows ⇒ Fig. 78(right magnifier).


4-door vehicles: The holes or markings for the attachment points of the base racks are located on the underside of the roof side rails and are only visible with the door open ⇒ Fig. 78.


Attach the base racks only at the markings shown in the figure ⇒ .


After fitting the base racks, attach the carrier system to the base racks according to the supplied installation instructions.

Vehicles with roof rails: attaching the crossbars and carrier system

Load bars are attached to the roof rails. Be sure to observe the installation instructions supplied with the load bars. Roof racks intended for vehicles without roof rails must not be used ⇒ .


The distance ⇒ Fig. 79 Ⓐ between the load bars should be 70 – 75 cm.

Attach the load bars only in the area shown in the illustration ⇒ Fig. 79 Ⓑ.

After the load bars have been installed, attach the carrier system to the load bars as described in the supplied installation instructions. Make sure there is sufficient clearance to the roof antenna to protect it from damage.

Warning
Improper attachment of the base racks and the carrier system, and improper use of them, may result in the entire system coming loose from the roof and causing accidents and injuries.
  • Always observe the manufacturer's installation instructions.
  • Use base carriers and carrier systems only if they are undamaged and properly secured.
  • Attach the base carriers only at the markings or areas shown in the illustrations ⇒ Fig. 78 or ⇒ Fig. 79.
  • Always install base carriers and carrier system correctly.
  • Check the bolted connections and fastenings before driving and retighten after a short drive if necessary. On longer trips, check bolted connections and fastenings at every break.
  • Always install special carrier systems for wheels, skis, surfboards, etc. correctly.
  • Do not modify or repair the base carriers or the carrier system.

Read and observe the supplied installation instructions for the base carriers,
load bars and the respective carrier system, and always carry them in the vehicle.