While driving

Starting the engine

~2min read
Read and observe the introductory information
and safety warnings first
⇒Introduction
to the topic
Carry out the actions only in the specified order.
Manual transmission Automated manual transmission
1. Press and hold the brake pedal until step 5 has been carried out. Turn the vehicle key in the ignition switch to position ⇒ Fig. 93①.
2. Fully depress and hold the clutch pedal until the engine has started. Press and hold the brake pedal until step 5 has been carried out.
3. Move the gear lever to the neutral position. Move the selector lever to position N.
4. Turn the vehicle key in the ignition switch to position ⇒ Fig. 93② – do not press the accelerator.
5. When the engine starts, release the vehicle key in the ignition switch.
6. If the engine does not start, abort the starting procedure and repeat after approximately one minute.
7. Release the parking brake when you want to drive off ⇒ Brakes, stopping and parking .
For CNG engine

The CNG engine always starts on CNG. Under the following conditions, the engine may start on petrol:

  • At very cold outside temperatures.
  • The mixture adaptation after refuelling is not yet complete.
  • The CNG fuel tank is empty.
Warning
Never leave the vehicle with the engine running, especially not with a gear or driving range engaged. The vehicle could move suddenly or an unusual event may occur that can cause damage, fire or serious injury.

Warning

A starting aid can explode
or cause the engine to rev up suddenly.

  • Never use a starting aid.
Note
  • The starter motor or engine can be damaged if an attempt is made to start the engine while driving, or if the engine is restarted immediately after being switched off.
  • When the engine is cold, avoid high engine speeds, full throttle and heavy engine load.
  • Do not push or tow the vehicle to start it. Unburnt fuel can damage the catalytic converter.

Do not let the engine warm up while stationary; instead, drive off immediately if visibility through the windows is clear. This allows the engine to reach its operating temperature more quickly and reduces pollutant emissions.

When the engine is started, larger electrical
consumers are temporarily switched off.

After starting a cold engine, increased running noises may occur temporarily
due to operating conditions. This is normal and harmless.