Care, Cleaning, Maintenance
Opening and closing the engine hood
In this manual: Care, Cleaning, Maintenance
~2min read
Fig. 118In the footwell on the left side of the vehicle: hood release lever. Above the radiator grille: hood opening lever.
Fig. 119On the hood:
Hood support rod in the holder. Hood raised and supported.
and safety warnings first⇒
to the topic Opening the engine hood
- Before opening the hood, make sure the wiper arms are resting against the windshield ⇒
.
- Pull the release lever in the direction of the arrow ⇒ Fig. 118
①. The hood springs out of the lock carrier latch by spring force.
⇒
.
- Lift the hood slightly and at the same time press the opening lever in the direction of the arrow ⇒ Fig. 118
②, to fully open the hood.
- Remove the hood support rod from the holder in the direction of the arrow ⇒ Fig. 119
③ and insert it into the opening ⇒ Fig. 119
④ insert.
- Lift the hood slightly ⇒
.
- Remove the hood support rod from the opening ⇒ Fig. 119
④ and insert it into the holder on the hood
⇒ Fig. 119
③.
- Let the hood drop into the lock carrier latch from a height of approx. 20 cm – do not push it down!
If the hood is not properly closed, lift the hood again and close it once more.
A properly closed hood sits flush with the surrounding body panels.
An engine hood that is not properly closed can suddenly open while driving and block the view ahead. This can cause accidents and serious injuries.
- After closing the hood, check that the latch in the lock carrier has engaged properly. The hood must sit flush with the surrounding body panels.
- If it is found while driving that the hood is not properly closed, stop immediately and close the hood.
- Only open or close the hood when no one is within its swing range.
- To avoid damage to the hood and wiper arms, open the hood only when the wipers are switched off and the wiper arms are placed against the windshield.
- Always place the wiper arms against the windshield before driving.
Was this page helpful?