Rally bar R-Design models

Rally bar and bulkhead hatch

Vehicles with the optional R-Design package are equipped with a rally bar in the engine compartment that must be removed before the battery can be replaced.

1. Remove the hatch in the bulkhead on both sides of the engine compartment (pry them up carefully with a plastic knife or similar object).

2. Remove the screw on each side of the engine compartment holding the rally bar in place.

3. Lift out the rally bar.

> The battery can now be removed (see the instructions in the previous section).

• After a new battery has been installed (see the following section), reinstall the rally bar in the reverse order.

NOTE

When reinstalling the rally bar, tighten the screws to 22 ft lbs (30 N·m).