Replacing the rear brake pads

NOTE:

When replacing the brake pads, it is not necessary to disconnect the brake hose or disassemble the brake caliper.

1. Remove:

• Brake pads
• Brake pad spring

NOTE:

To remove the inner brake pad "1", push down on the brake caliper bracket so that there is space to remove the brake pad.

2. Measure:

Brake pad wear limit "a" Out of specification → Replace the brake pads as a set.

3. Install:

• Brake pad spring


• Brake pads

NOTE:

Always install new brake pads and a new brake pad spring as a set.

a. Connect a clear plastic hose tightly to the bleed screw. Put the other end of the hose into an open container.

b. Loosen the bleed screw and push the brake caliper piston into the brake caliper with your finger.

c. Tighten the bleed screw.

d. Install a new brake pad spring "1" and new brake pads.

NOTE:

Install the brake pad spring as shown.

4. Install:

• Brake pad retaining bolts
• Brake caliper

5. Install:

• Rear wheel Refer to "REAR WHEEL" on page 4-12.

6. Check:

• Brake fluid level Below the minimum level mark "a" Add the
  recommended brake fluid to the proper level.

Refer to "CHECKING THE BRAKE FLUID LEVEL" on page 3-18.

7. Check:

• Brake pedal operation Soft or spongy feeling Bleed
  the brake system.

Refer to "BLEEDING THE HYDRAULIC BRAKE SYSTEM" on page 3-20.