Body

Bracket, Removing and Installing

~1min read

Special tools and workshop equipment required

  • Pry Lever -80-200-

Caution

There is a risk of malfunctions.

The door lock must be removed and installed together with the bracket to prevent over-bending the cable when disengaging and engaging it.

The cable must be disconnected from/attached to the lever on the door lock outside of the door.

Removing

- Remove the door trim panel. Refer to → Body Interior; Rep. Gr.70; Front Door Trim Panels; Front Door Trim Panel, Removing and Installing.

- Remove the inner door panel cover. Refer to → Chapter "Door Inner Cover, Removing and Installing".

- Remove the outside door handle. Refer to → Chapter "Exterior Door Handle, Removing and Installing".

- Remove the lock cylinder guide. Refer to → Chapter "Lock Cylinder Guide, Removing and Installing".

- Disengage the electric wire on the mounting bracket -arrow- if applicable.

- Free up the spiral clip -1- from the wire using the Pry Lever -80 - 200-.

Note

Use a soapy solution if necessary make removal easier.

- Remove the bolt -3- and the mounting bracket -2-.

A57-10321

- Remove the bolts -arrows- from the door lock.

- Disconnect the connector -2-.

- Push the bracket and door lock -1- downward and remove them from the vehicle.

- If the bracket is to be replaced, also remove the following components:

  • Remove the door lock cable. Refer to → Chapter "Door Lock Cable, Removing and Installing".

Installing

Install in reverse order of removal.

A57-10324