Body

Vehicle Positioning System Interface Control Module -J843-, Removing and Installing

~2min read
010203040501.51N·mlb·ft
Tightening torque found on this page

Removing

- Open the cover in the luggage compartment right trim panel.

- Disconnect the control module connectors -1-.

- Release the tab -arrow- and remove the control module.

Installing

Install in reverse order of removal.

A57-10649

Engine Hood Contact Switch -F266-, Removing and Installing

Removing

- Remove the hood latch. Refer to → Chapter "Overview - Hood, Hood Latch".

- Raise the retaining tab -2--arrow A-.

- Disengage the hood switch -F266--item 1- from the lock -4--arrow B- and remove it.

Installing

Install in reverse order of removal. Note the following:

  • The centering pins -3- on the engine Hood Contact Switch -F266- must fit correctly inside the hood lock.
A57-10392

Fuel Filler Door Unlock Motor -V155-, Removing and Installing

Fuel Filler Door Unlock Motor -V155-, Removing and Installing

1 - Drain Hose

  • Routing

2 - Emergency Release Cable

  • Routing

3 - Bolt

  • 1,5 N·m

4 - Fuel Filler Door Unlock Motor -V155-

  • Removing
    • The fuel filler door is removed. Refer to → Chapter "Fuel Filler Door Unit, Removing and Installing".
    • Remove the bolt -3- on the Fuel Filler Door Unlock Motor -V155-.
    • Disconnect the connector and remove the Fuel Filler Door Unlock Motor -V155-.
  • Installing
    • Connect the fuel filler door to the Fuel Filler Door Unlock Motor -V155- with the bolt -3-.
    • Push the drain hose and emergency release cable through the cut-out in the side panel.
    • Install the fuel filler door with the Fuel Filler Door Unlock -V155- at an angle in the tank opening and push in until the retaining tabs on the flange engage.
    • pay attention that the drain hose.

5 - Fuel Filler Door Cover

  • Removing and installing. Refer to → Chapter "Fuel Filler Door Cover, Removing and Installing".

6 - Fuel Filler Door Unit

  • Must be replaced after removing
  • Removing. Refer to → Chapter "Fuel Filler Door Unit, Removing and Installing"

Special Tools

Special tools and workshop equipment required

  • Roller -3356-
W00-0202
  • Pry Lever -80 - 200-
  • Front and Rear Door Template -T40038/8-
W00-11156
  • Gauge - Gap Adjustment -3371-
W00-11140
  • Front and Rear Door Template -T40038 /14-
A57-10678
  • Adhesive Strip Remover -VAS6349-
W00-10390