Transmission

Flange Shaft Seals, Replacing, Rear Final Drive Removed

~2min read
  • The shaft seal can be only be replaced with the final drive removed.

Special tools and workshop equipment required

  • Slide Hammer Set -VW771-
  • Seal Installer - Drift Shaft -T40221-
  • ATF

Removing

- Follow all general repair information. Refer to → Chapter "General Repair Information".

- Remove the rear final drive. Refer to → Chapter "Rear Final Drive, Removing and Installing, Audi A4, A5 Coupé/Sportback/Cabriolet, A6, A7".

- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using an assembly lever.

- Remove the flange shaft.

Note

If it not possible to remove the flange shaft by hand, then use the Slide Hammer Set -VW771- to remove it.

A39-10380

- Remove flange shaft seal with the Slide Hammer Set -VW771- and Slide Hammer Set - Hook -VW771/37-.

Installing

Install in reverse order of removal. Pay attention to the following:

A39-10381

Install Right Shaft Seal

- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

- Install the shaft seal all the way. Be careful not to bend it.

A39-10382

Installing Left Shaft Seal

- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

- Install the shaft seal all the way. Be careful not to bend it.

- Install the flange shaft.

Note

If it is not possible to install the flange shaft all the way in by hand, then use a plastic mallet.

- Tighten the new flange shaft bolt to the tightening specification -item 1-.

- Install the rear final drive. Refer to → Chapter "Rear Final Drive, Removing and Installing, Audi A4, A5 Coupé/Sportback/Cabriolet, A6, A7".

- Check the ATF level in the rear final drive. Refer to → Chapter "ATF Level in Rear Final Drive 0BF and 0BE, Checking".

A39-10383

Flange Shaft Protective Ring, Replacing

Special tools and workshop equipment required

  • Press Plate -VW401-
  • Press Plate -VW402-
  • Press Piece - Multiple Use -VW412-
  • Bearing Installer - Differential Bearing -40-21-
  • Seal Installer - Flywheel Oil Seal Kit - Press Sleeve -2003/1- from the Seal Installer - Flywheel Oil Seal Kit -2003-
  • Bearing Installer - Wheel Bearing -3345-
  • Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm -17/2-

Removing the Protective Ring -A- from the Flange Shaft

B - Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm -17/2-

A39-10384

Carefully Press the Ring -A- onto the Flange Shaft.

  • Protective ring installation location -A-: The larger outer diameter on the protective ring faces the Bearing Installer - Wheel Bearing -3345-.
A39-10385