Chassis

Front Brake Rotor, Replacing

~2min read
Front Brake Rotor, Replacing

Removing

- Remove the brake caliper -2-.

- Remove the locking pin-5- on the brake rotor -4- while holding the brake rotor firmly.

- Remove the brake rotor from the wheel hub.

Note

When removing the brake rotor from the wheel hub, do not tilt the brake rotor.

Installing

  • Tightening Specifications

Note

  • Only install brake rotors from the same manufacturer and with the same quality level on a single axle.
  • Always replace brake rotors on both sides of the axle.
  • Use new bolts.

- Clean the contact surface on the wheel hub. Remove any corrosion.

- Place the brake rotor on the hub.

Note

When positioning the brake rotor, do not tilt it on the wheel hub.

- Install the securing bolt -5- and tighten.

- Install the brake caliper -2-.

WARNING

Risk of accident!

  • With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
  • Make sure the brakes are working correctly before driving the vehicle for the first time.

Front Brake Shield, Removing and Installing

Special tools and workshop equipment required

  • Torque Wrench 1331 5-50Nm -VAG1331-

Removing

- Remove the brake rotor. Refer to → Chapter "Brake Rotor, Removing and Installing".

- Remove the bolts -arrows- and the cover plate -1-.

Note

The brake shield is shown on a vehicle with ceramic brakes.

Installing

Install in reverse order of removal and note the following:

- Clean the brake shield and the wheel hub.

- Install the brake rotor. Refer to → Chapter "Brake Rotor, Removing and Installing".

WARNING

Risk of accident!

  • With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
  • Make sure the brakes are working correctly before driving the vehicle for the first time.
A46-10205