Chassis

Rear Brake Pad Wear Indicator Wire, Removing and Installing

~3min read

Brake Pad Wear Indicator Wire, Removing and Installing, Steel Brakes

Note

The brake pad wear sensor contacts cannot be removed without damaging them.

Removing

- Remove the affected rear wheel. Refer to → Suspension, Wheels, Steering; Rep. Gr.44; Wheels, Tires.

- Disconnect the brake pad wear sensor connector -1-.

- Release the connector -2- to the brake pad wear sensor from its bracket -arrow B- while turning it 90º at the same time -arrow A-.

- Remove the dust cap -3- from the bleed screw and free up the electrical wire.

- Remove the brake pad wear sensor contact -4- with pliers.

A46-10279

Installing

- Insert the new contact -1- for the brake pad wear sensor into the inner brake pad until it engages.

Note

Make sure that the brake pad wear sensor contact sits correctly in the brake pad.

- Secure the electrical wire for the brake pad wear sensor with the dust cap -2- as illustrated.

- Bring the connector -3- into its installed position and turn in the direction of the -arrow- until the tab -4- engages in the hole -5- on the bracket.

- Assemble connector -6-.

- Install the rear wheel. Refer to → Suspension, Wheels, Steering; Rep. Gr.44; Wheels, Tires.

A46-10280

Brake Pad Wear Indicator Wire, Removing and Installing, Ceramic Brakes

Note

The brake pad wear sensor contacts cannot be removed without damaging them.

Removing

- Remove the affected rear wheel, while observing the safety precautions for vehicles with ceramic brakes. Refer to → Suspension, Wheels and Steering; Rep. Gr.44; Wheels, Tires.

- Unclip the bracket -3- with a screwdriver -2--arrow-.

- Free up the brake pad wear indicator wire -1-.

A46-10208

- Disconnect the brake pad wear sensor connector -1-.

- Release the connector -2- to the brake pad wear sensor from its bracket -arrow B- while turning it 90º at the same time -arrow A-.

- Remove the dust cap -3- from the bleed screw and free up the electrical wire.

- Remove the brake pad wear sensor contacts -4- with pliers.

A46-10253

Installing

- Insert the brake pad wear sensor contacts -5- into the brake pads until they engage.

Note

Make sure that the brake pad wear sensor contacts fit correctly in the brake pads.

- Secure the electrical wire for the brake pad wear sensor with the dust cap -4- as illustrated.

- Bring the connector into its installed position and turn in the direction of the -arrow- until the tab -1- engages in the hole -2- on the bracket.

- Connect the connector -3-.

A46-10257

- Guide the electrical wire -1- for the brake pad wear sensor into the bracket -3- as illustrated.

- Clip the bracket into the brake caliper.

Note

Ignore -item 2- and -arrow-.

- Install the rear wheel, while observing the safety precautions for vehicles with ceramic brakes. Refer to → Suspension, Wheels and Steering; Rep. Gr.44; Wheels, Tires.

A46-10208