Ambient Air Temperature Sensor R&R

1. 1
   Remove front fascia.
2. 2
   Remove push-in retainer that secures ambient air temperature sensor to impact bar, Fig. 1.
3. 3
   Disconnect electrical connector from ambient air temperature sensor, Fig. 1.
4. 4
   Remove sensor from vehicle, Fig. 1.
5. 5
   Reverse procedure to install.

Fig. 1

In the 2016 Chevrolet Captiva, the ambient air temperature sensor plays a crucial role in providing accurate temperature readings to the vehicle's climate control system. To access and remove this sensor, you'll need to follow a few steps. Begin by locating the sensor, which is usually situated in the front grille area or behind the front bumper. Refer to your vehicle's service manual for precise guidance on its exact location. Before starting any work on the ambient air temperature sensor, it's essential to prioritize safety. Begin by disconnecting the vehicle's battery to prevent any electrical mishaps. This precautionary step ensures that you can work on the sensor without risking damage to the vehicle's electrical system. Once the battery is disconnected, you can proceed with accessing and removing the sensor.

To remove the ambient air temperature sensor, you'll typically need to remove parts of the front grille or bumper to gain access. This may involve undoing clips, screws, or fasteners holding these parts in place. Once you have access, disconnect the electrical connector attached to the sensor and then remove the sensor from its mounting position. After inspecting for any damage and replacing if necessary, reassemble the removed parts and reconnect the vehicle's battery to complete the process.