Quiz: how well do you know your Chevrolet Captiva?

21 questions. After each answer you get a short explanation and a link to the manual page that covers it in detail.

When cleaning a Captiva battery with baking soda solution, what must you keep the solution out of?
The battery vent holes. Baking soda solution entering the vent holes can damage the battery. Apply it with a bristle brush, let it loosen acid deposits, then rinse and blot dry. Battery Cable Terminal End Service

Which front wheel alignment angle on the Captiva is NOT adjustable?
Front caster. Front caster can't be adjusted; if it is out of spec, look for suspension support misalignment or damage. Front camber is adjusted without removing the strut. Wheel Alignment Adjust

How long does a remotely started Captiva run before shutting off automatically, unless extended?
10 minutes. The engine shuts off after 10 minutes. Run time can be extended by 10 minutes, only once, and only if it is the first remote start since the vehicle was driven. Remote Vehicle Start

What does the arrow on the Captiva fuel gauge show?
Which side the fuel door is on. The arrow shows the side of the fuel door. Also, the pump clicking off before the gauge reads full is normal and not a gauge fault. Fuel Gauge

What diameter holes are drilled for plug welds when installing a front upper outer rail?
5/16 inch. Drill 5/16 inch plug weld holes at the noted original locations. If they can't be determined, space them 1 1/2 inches apart; also disable the SIR system first. Upper Frame Rail

Before starting a power steering leak inspection, what should you do with the components?
Clean all components, hoses and lines. Cleaning first helps narrow down where the leak originates. Then fill the reservoir to the full line, run the engine and turn the wheel lock to lock. Power Steering System Leak Inspection

Why must you not remove the radiator cap on a hot Captiva engine?
Hot fluid and steam can blow out. Pressurized fluid and steam can burn you. In the pressure test, the tester is kept above 30° from horizontal and relief valve opening pressure is compared to the cap. Cooling System Pressure, Test

If you hold the key in START and the Captiva engine doesn't fire, when does cranking stop automatically?
After 15 seconds. Cranking stops after 15 seconds to protect the starter, and you should wait at least 15 seconds between attempts. Don't turn the wheel to full lock while starting. Starting the Engine

What is the first step when replacing a Captiva heater hose?
Drain the cooling system into a container. Drain the coolant first, then reposition the clamps at the heater core and inlet pipe. Installation is the reverse order. Heater Hose, Replace

When centering an air bag clockspring (Type 1), where should the steering shaft centering mark be?
6 o'clock position. Wheels straight ahead and mark at 6 o'clock; the coil is turned clockwise to its stop, then back about three turns until the window turns yellow. Component Service

How do you change airflow direction at a Captiva air vent?
Move the louvers up or down. The louvers move up or down but do not turn; the thumbwheel opens or closes the airflow. Keep the area under the front seats clear for better circulation. Air Vents

Where must a rear-facing child seat be installed in the Captiva?
In a rear seat. Never put a rear-facing seat in front, even if the airbag is off—no system is fail-safe. A forward-facing seat in front needs the seat as far back as possible. Securing Child Restraints (Front Passenger Seat)

What is the tightening torque for the Captiva drive belt idler pulley bolt?
16 ft. lbs.. The idler pulley bolt is torqued to 16 ft. lbs. The drive belt must be removed first and refitted per the routing diagram afterwards. Drive Belt Idler Pulley R&R

How do the Captiva heated seat settings step with each button press?
Highest first, then lower, then off. First press gives the highest setting, then each press goes lower and finally off. Two lights show highest, one lowest; the ignition must be on. Heated Seats, Head Restraint Adjustment, Safety Belts, Passenger Sensing System

What can an improperly adjusted stop lamp switch on the Captiva cause?
Brake drag and excessive lining wear. Correct adjustment is essential. After sliding the switch in, twist it clockwise 60° to lock it; clearance should then be .008-.47 inch. Brake Light Switch R&R

After a scheduled service on your Captiva, what should you record and keep?
Date, odometer, who serviced, services done; keep receipts. Records help with warranty claims and resale value. Write the details in the boxes provided and retain all maintenance receipts. Maintenance Records

After a battery is disconnected, a Captiva window loses express up/down. What restores it?
Normalizing: hold switch about 5 s at full open, then at full closed. Ignition ON, hold the switch down about five seconds after fully open, then up about five seconds after fully closed. Glass or regulator replacement needs a scan tool relearn. Power Window Reset

What must you avoid on exhaust isolators when replacing the Captiva tailpipe?
Oil or grease-based lubricants. Oil or grease can deteriorate the rubber, letting the isolator separate from the hanger bracket while driving. Let the hot exhaust cool before working. Exhaust Tail Pipe, Replace

A Captiva TPMS light comes on in cold weather. Why might it go off later?
Tire pressure rises as tires warm up while driving. Low temperature can lower pressure, and it rises as ambient temperature increases or tires warm up. Non-GM tire sealants can also block the sensor port. Diagnosis & Testing

How should you remove brake dust when servicing Captiva parking brake shoes?
Water-dampened cloth. Dust may contain asbestos fibers, so use wet methods. Clean grease with denatured alcohol and apply high temperature silicone grease at contact points. Parking Brake Shoes R&R

What does the dome lamp override button on the Captiva overhead console do?
Keeps dome lamps off when a door opens. Pressing it keeps interior lamps off while any door is open; pressing again restores automatic operation. The panel dimmer is a thumbwheel by the steering wheel. Interior Lighting

← Back to the manuals