Installation Procedure

1. Position the front brake shield (2) and front wheel bearing/hub (1) assembly in the steering knuckle.

Caution: Refer to Fastener Caution in the Preface section.

1. 1
   Install the NEW front wheel bearing/hub bolts (1).
2. 2
   Tighten the bearing/hub bolts (1) in 3 passes. Use the EN-45059 kit .

• First pass to 90 N·m
• Second pass to 60°
• Third pass to 15°

1. 1
   Install the wheel drive shaft at the front wheel bearing/hub. Refer to Front Wheel Drive Shaft Replacement - Left Side or Front Wheel Drive Shaft Replacement - Right Side.

   

2. 2
   Install the wheel speed sensor (1) to the steering knuckle.
3. 3
   Install the wheel speed sensor screw (2) and tighten to 6 N·m.
4. 4
   Install the brake rotor. Refer to Front Brake Rotor Replacement.
5. 5
   Remove the support and lower the vehicle.