Rear Bumper Fascia Replacement

Preliminary Procedure

Remove the tail lamps. Refer to Tail Lamp Replacement.

1. 1
   Rear Bumper Fascia Retainer (Qty: 2)
2. 2
   Rear Wheelhouse Liner Bolt (Qty: 6) Caution: Refer to Fastener Caution in the Preface section.

Tighten 2,5 N·m

3. Rear Bumper Fascia

Procedure

1. 1
   Pull the rear bumper fascia rearwards at the front edge to load the three clips on the inboard fascia guides (under the tail lamp position)
2. 2
   Release the clips with an suitable tool
3. 3
   Continue to pull the rear bumper fascia rearwards until the outer edges pop outboard.
4. 4
   Disconnect any electrical connectors as needed
5. 5
   Remove the rear bumper fascia.
6. 6
   Transfer parts as needed.