Rear lamps

1. Open both covers.

2. Unscrew both screws.

3. Remove the rear lamp assembly.

Make sure the wiring harness remains in its position.

4. Back-up lamp (1)

Turn signal lamp (2)

Rear marker lamp / stop lamp (3)

5. Turn the bulb socket counterclockwise.

6. Remove the bulb socket.

Push the bulb socket slightly into the housing, turn it counterclockwise, remove it and replace the bulb.

7. Insert the bulb holder into the rear lamp and secure it with the screws. Connect the harness connector. Install the rear lamp on the body and tighten the screws. Install the covers and snap the retainers into place.

8. Turn on the ignition, then switch on and check the operation of all lamps.