Removal and Installation - Rear Seat

Special Service Tools / General Equipment

Interior trim removal tool

Removal

1. 1
   Disable the SRS.
   Refer to: Supplemental Restraint System (SRS) Disabling (501-20B Supplemental Restraint System, General Procedures).
2. 2
   Position the rear seat in the full rearward position.

   

3. 3
   Release the retainers and remove the rear seat front bolt covers.
   Use common equipment: interior trim removal tool.

   

4. 4
   Remove the rear seat front bolts.
   Torque: 30 lb-ft (40 N·m)

   

5. 5
   Disconnect the rear seat electrical connector.

   

6. 6
   Position the rear seat to the full forward position.

   

7. 7
   Route the rear seat safety belt through the safety belt guide.

   

8. 8
   Fold the rear seatback into the horizontal position.

   

9. 9
   Remove the rear seat nuts.
   Torque: 52 lb-ft (70 N·m)

   

10. 10
    Remove the rear seat.

    

Installation

1. 1
   To install, reverse the removal procedure.
2. 2
   Reset the SRS.
   Refer to: Supplemental Restraint System (SRS) Reset (501-20B Supplemental Restraint System, General Procedures).