Antenna Cable — Satellite Radio

For coupe, remove the C-pillar trim panels. For additional information, refer to Interior Trim — Exploded View in Section 501-05.

For sedan, remove the LH and RH quarter trim panels. For additional information, refer to Quarter Trim Panel — 4-Door in Section 501-05.

NOTE: To prevent damage to the garment hanger retainer, use a 3/16-inch flat-blade screwdriver for this step. NOTE:

The garment hanger is shown without the roof sheet metal to show the metal retainer clip. The metal retainer clip remains engaged in the sheet metal after the garment hanger is removed.

Remove the 2 garment hangers.

1. Open the garment hanger access cover.

2. Insert the flat-blade screwdriver fully into the garment hanger slot.

3. Rotate the screwdriver 90 degrees so that the screwdriver spreads the metal retainer clip. Remove the plastic garment hanger.

Remove the RH front and RH rear scuff plate trim panels. For additional information, refer to Section 501-05.

Remove the RH lower cowl trim panel. For additional information, refer to Interior Trim — Exploded View in Section 501-05.

Remove the Audio Front Control Module (ACM) . For additional information, refer to Audio Control Module (ACM) in this section.

Remove the satellite radio antenna cable.

To install, reverse the removal procedure.