Chassis
Brake Caliper
In this manual: Chassis
4steps
~29min
2/5difficulty
1special tools
Done 0 of 4
Material
Removal and Installation
WARNING: Do not
use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.WARNING: Carefully
read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury. NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
| Item | Specification |
|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) | WSS-M6C62-A or WSS-M6C65-A1 |
| Item | Part Number | Description |
|---|---|---|
| 1 | W712276 | Brake caliper flow bolt |
| 2 | W712362 | Copper washers |
| 3 | — | Brake caliper guide pin bolt (2 required) (part of 2386) |
| 4 | 2B120 | Brake caliper |
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury. NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
- Remove the wheel and tire. For additional information, refer to Section 204-04.
- Remove the brake caliper flow bolt and position the brake flexible hose aside.
- Discard the 2 copper washers.
- To install, tighten bolt to 48 N·m.
- Remove the 2 brake caliper guide pin bolts and remove the brake caliper.
- To install, tighten to 28 N·m.
- To install, reverse the removal procedure.
- Install new copper washers.
- Bleed the brake caliper. For additional information, refer to Section 206-00 for Component Bleeding.
Test yourself
A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?