Chassis
Brake Flexible Hose
In this manual: Chassis
4steps
~29min
2/5difficulty
1special tools
Done 0 of 4
Material
Removal and Installation
WARNING: Do not
use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.WARNING: Carefully
read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury. NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
| Item | Specification |
|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) | WSS-M6C62-A or WSS-M6C65-A1 |
| Item | Part Number | Description |
|---|---|---|
| 1 | W712276 | Brake caliper flow bolt |
| 2 | — | Brake tube fitting (part of 2C287) |
| 3 | W712362 | Copper washers |
| 4 | W700936 | Brake flexible hose retaining clip (2 required) |
| 5 | 2078 | Brake flexible hose |
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury. NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
- Remove the brake caliper flow bolt and discard the 2 copper washers.
- To install, tighten to 48 N·m.
- Disconnect the brake tube fitting from the brake flexible hose.
- To install, tighten to 15 N·m.
- Remove the 2 brake flexible hose retaining clips and the brake flexible hose.
- To install, reverse the removal procedure.
- Install new copper washers.
- Bleed the brake caliper. For additional information, refer to Section 206-00 for Component Bleeding.
Test yourself
A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?