Ford Focus Service Manual: Starter Motor

Item	Part Number	Description
1	W704141	Starter solenoid wire nut
2	W701596	Starter solenoid battery cable nut
3	14a280	Starter motor solenoid wire harness terminal cover
4	13a506	Engine Oil Pressure (EOP) switch wire harness retainer (part of 12C508)
5	W520101	Power steering tube bracket nut
6	—	Power steering tube bracket (part of 3A719)
7	W701073	Starter motor bolt
8	W706194	Starter motor stud bolt
9	11000	Starter motor

Removal and Installation WARNING: Always
disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.

1
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
2
Disconnect the battery ground cable. For additional information, refer to Section 414-01.
3
Remove the starter solenoid wire nut.
- To install, tighten to 5 N·m.
4
Remove the starter solenoid battery cable nut and the starter motor solenoid wire harness terminal cover.
- To install, tighten to 12 N·m.
5
Detach the Engine Oil Pressure (EOP) switch wire harness retainer from the starter stud bolt.
6
Remove the power steering tube bracket nut and position the power steering tube and bracket aside.
- To install, tighten to 20 N·m.
7
Remove the upper bolt, the lower stud bolt and the starter motor.
- To install, first install the upper bolt and lower stud bolt finger-tight.
- Tighten the upper bolt to 35 N·m.
- Tighten the lower stud bolt to 35 N·m.
8
To install, reverse the removal procedure.

Starter Motor

Test yourself