Disassembly

1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section.

2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing driveshaft failure during vehicle operation.

Place the driveshaft (4602) on a suitable workbench. Be careful not to damage the tube.

3. NOTE: If components are not marked and therefore installed incorrectly, driveline imbalance can occur.

Index-mark the driveshaft components.

4. Clamp the special tool in a vise.

5. Remove all four of the snap rings.

6. NOTE: If necessary, use a pair of pliers to remove a bearing cup if it cannot be pressed out all the way.

Remove the driveshaft slip yoke (4841).

1. Position the driveshaft slip yoke in the U-joint tool.

2. Press out a bearing cup.

3. Rotate the driveshaft slip yoke.

4. Press on the spider to remove the remaining bearing cup.

5. Remove the driveshaft slip yoke.

7. Repeat Step 5 to remove the remaining bearing cups and spider from the driveshaft.

8. Clean the yoke area at each end of the driveshaft.