Halfshaft Joint

Special Tool(s)

	Driver 205-199 (T83T-3132-A1)
	Hub Bearing Cup Replacer 205-147 (T80T-4000-P)
	Sensing Ring Replacer 206-041 (T89P-20202-A)

Disassembly

1. CAUTION: Do not disassemble the halfshaft assembly. Install a new assembly if worn or damaged.

Remove the halfshaft from the vehicle. For additional information, refer to Halfshaft in this section.

2. If necessary, remove the dust seal assembly (2217).

1. Tap uniformly around the dust seal assembly.

2. Slide the dust seal assembly from the shaft.

3. Using a suitable bearing plate and a press, remove the rear brake anti-lock sensor indicator, if necessary.

Assembly

1. Using the special tool and a hammer, install the new dust seal assembly, if removed.

2. CAUTION: Place only the inboard CV joint outer race land on the bearing plate. Do not press against any other portion of the outer race or damage will occur.

If removed, using the special tools, the bearing plate and a suitable press, seat the rear brake anti-lock sensor indicator against the inboard CV joint housing.

3. Install the halfshaft in the vehicle. For additional information, refer to Halfshaft in this section.