Ford Mustang Quiz
Brake System

Installation

In this manual: Brake System
Service Information — 34Suspension — 63Driveline — 80Brake System — 74Steering System — 42Engine — 329Automatic Transmission — 84Manual Transmission, Clutch and Transfer Case — 64Exhaust System — 8Fuel System — 39Climate Control System — 76Instrumentation and Warning Systems — 25Battery and Charging System — 19Audio Systems — 14Lighting — 24Electrical Distribution — 8Electronic Feature Group — 11Body — 173Frame and Mounting — 6General Information — 1
~1min read

1. CAUTION: Install the brake pads in full axle sets. Do not install new brake pads on only one side of vehicle.

Install the new slipper and brake pads.

Pads

2. Position the caliper on the anchor plate and install the bolts.

Pads

3. Install the wheel and tire assembly.

4. Lower the vehicle.

5. WARNING: Use of any other than approved DOT 3 or DOT 4 brake fluid will cause permanent damage to components and will render the brakes inoperative.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.

CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

Check the fluid level at the master cylinder. Add fluid if necessary.

6. WARNING: Pump the brake pedal several times to make sure the caliper piston is extended to its operating position. Failure to follow these instructions may result in personal injury.

Verify correct brake operation.

7. Recheck the master cylinder fluid level.

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.