Ford Mustang Quiz
Brake System

Sensor - Rear

In this manual: Brake System
Service Information — 34Suspension — 63Driveline — 80Brake System — 74Steering System — 42Engine — 329Automatic Transmission — 84Manual Transmission, Clutch and Transfer Case — 64Exhaust System — 8Fuel System — 39Climate Control System — 76Instrumentation and Warning Systems — 25Battery and Charging System — 19Audio Systems — 14Lighting — 24Electrical Distribution — 8Electronic Feature Group — 11Body — 173Frame and Mounting — 6General Information — 1
~1min read

Removal

1. Remove the rear passenger seat.

2. Disconnect the rear anti-lock brake sensor electrical connector.

Sensor - Rear

3. Raise and support the vehicle. 4. Remove the rear anti-lock brake sensor harness from the floor pan.

Sensor - Rear

5. Remove the anti-lock brake sensor harness bracket bolt.

Sensor - Rear

6. NOTE: The sensor may be siezed to the axle. Use Rust Penetrant and Inhibitor F2AZ-19A501- A meeting Ford specification ESR-M99C56-A to loosen the sensor for removal.

Remove the rear anti-lock brake sensor.

1. Remove the rear anti-lock brake sensor bolt.

2. Remove the rear anti-lock brake sensor.

Sensor - Rear

Installation

1. NOTE: Be sure to apply High Temperature Nickel Anti-Sieze Lubricant F6AZ-9L494-AA meeting Ford specification ESE-M124A-A to the sensor body where it will make contact when installed.

To install, reverse the removal procedure.

Sensor - Rear

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.