Steering System

System Flushing - CIII Power Steering Pump

~2min read

WARNING: Do not mix oil types. Any mixture or any unapproved oil can lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering assist.

1. Remove the fuel pump fuse from the battery junction box.

2. Disconnect the power steering return hose. Plug the reservoir.

System Flushing -CIII Power Steering Pump

3. Attach an extension hose between the power steering return hose and an empty container.

4. Raise the front wheels off the floor.

5. Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

6. CAUTION: Do not crank the engine for more than 15 seconds at a time. Allow the starter to cool for 1 minute before cranking again. Premature starter failure can occur.

CAUTION: Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump could occur.

Turn the steering wheel from stop-to-stop while cranking the engine until the fluid exiting the power steering return hose is clear of all contamination and foreign material.

  • Add Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent as needed.

7. Lower the vehicle.

8. Disconnect the extension hose from the power steering return hose. Remove the plug. Attach the power steering return hose to the reservoir.

System Flushing -CIII Power Steering Pump

9. CAUTION: Do not overfill the reservoir.

Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

10. Install the fuel pump fuse.

11. CAUTION: Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump will occur.

Start the engine and turn the steering wheel from stop-to-stop.

12. CAUTION: Do not overfill the reservoir.

NOTE: If the power steering system is noisy and is accompanied by evidence of aerated fluid it will be necessary to purge the power steering system.

Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.