Honda Civic Quiz
Powertrain

Automatic Transmission End Crankshaft Oil Seal Replacement - In Car (A/T)

In this manual: Powertrain
Accessories — 57Body — 310Chassis — 96Electrical — 15HVAC — 39Powertrain — 300Moonroof/Sunroof — 9Roof Drainage — 5Wiper Arm/Nozzle Adjustment — 1ELD Removal and Installation — 1Under-Dash Fuse/Relay Box Removal and Installation (KA KX models without Keyless Access System) — 1Under-Dash Fuse/Relay Box Removal and Installation (KA models with Keyless Access System) — 1
~1min read

1111M2 TRANSMISSION SIDE

Removal

  1. Drive Plate Assembly

1.

Remove the drive plate (A) and the washer (B).

  1. Crankshaft Oil Seal Transmission Side (In Car)

1.

Remove the transmission end crankshaft oil seal.

Installation

  1. Crankshaft Oil Seal Transmission Side (In Car)

1.

Clean and dry the crankshaft oil seal housing.

2.

Apply a light coat of new engine oil to the crankshaft and to the lip of the crankshaft oil seal.

3.

Use the driver handle, 15 x 135L and oil seal driver attachment, 96 mm to drive a new crankshaft oil seal (A) squarely into the engine block to the specified installed height.

4.

Clean the excess oil off the crankshaft, and check that the oil seal lip is not distorted.

  1. Drive Plate Assembly

  1. 1.

    Install the drive plate (A) and the washer (B), and tighten the eight bolts in a crisscross pattern in at least two steps.

Test yourself

A quick Honda Civic quiz: every answer comes with an explanation and a link to the manual page.