Body
Moonroof Drain Channel Removal and Installation (4-door)
8141D0
Removal
- Moonroof Link Cover Both
 |
|
2. |
Remove the moonroof link cover (B). |
|
3. |
Repeat on the opposite side. |
|
- Moonroof Glass
 |
|
2. |
Repeat on the opposite side. |
|
 |
|
3. |
Remove the moonroof glass (A). |
|
- Drain Channel
 |
|
1. |
Tilt up the glass bracket (A). |
|
2. |
Disconnect the drain channel rods (B). |
|
 |
|
3. |
Slide the drain channel (A) forward. |
|
 |
|
4. |
Remove the drain channel (A). |
|
Installation
- Drain Channel
 |
|
1. |
Install the drain channel (A). |
|
 |
|
2. |
Slide the drain channel (A) rearward. |
|
 |
|
3. |
Connect the drain channel rods (A). |
|
4. |
Tilt down the glass bracket (B). |
|
- Moonroof Glass
 |
|
1. |
Install the moonroof glass (A). |
|
 |
|
3. |
Repeat on the opposite side. |
|
- Moonroof Glass - Position Check
 |
Check the roof panel (A) should be even with the glass weatherstrip (B), to within 0.1+1/-1 mm (0.004+0.04/-0.04 in) all the way around. |
- Moonroof Glass - Position Adjustment
 |
|
1. |
Adjust the moonroof glass (A) position. |
|
2. |
If necessary, repeat on the opposite side. |
|
- Moonroof Link Cover Both
 |
|
1. |
Install the moonroof link cover (A). |
|
3. |
Repeat on the opposite side. |
|
- Moonroof Control Unit - Reset
|
Resetting the moonroof is required when any of the following have occurred:
|
 |
The moonroof was moved manually while the battery was dead or disconnected. |
|
|
 |
The moonroof motor was replaced with a new one. |
|
|
 |
Any of components related to the moonroof were replaced. |
|
|
To reset the moonroof control unit, do these steps:
|
1. |
Close the driver’s door, and keep it closed until the procedure is complete. |
|
2. |
Turn the ignition switch to LOCK (0). |
|
3. |
Press and hold the tilt switch, and turn the ignition switch to ON (II). |
|
4. |
Release the tilt switch, and turn the ignition switch to LOCK (0). |
|
5. |
Repeat steps 3 and 4 four more times. |
|
6. |
Press and hold the moonroof open switch for at least 3 additional seconds after the moonroof is fully opened. |
|
7. |
Press and hold the moonroof close switch for at least 3 additional seconds after the moonroof is fully closed (tilted). |
|
8. |
Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function. |
|
?
Test yourself
A quick Honda Civic quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?