Chassis

Hydraulic Power Steering Hose, Line, and Pressure Switch Replacement

~1min read
010203040502921N·mlb·ft
Tightening torque found on this page

Note these items during installation:

  • Connect each hose to the corresponding line securely until it contacts the stop on the line. Install the clamp or adjustable clamp at the specified distance from the hose end as shown.

  • Check all clamps for deterioration or deformation; replace the clamps with new ones if necessary.

  • Add the recommended power steering fluid to the specified level on the reservoir, and check for leaks.

ADJUSTABLE HOSE CLAMP (A)HOSE CLAMP (B)2.5-5.5 mm(0.098-0.216 in)2.0-4.0 mm(0.079-0.157 in)2.5-5.5 mm(0.098-0.216 in) RETURN LINE JOINT16 x 1.5 mm29 N·m(3.0 kgf·m, 21 lbf·ft)POWER STEERINGPRESSURE SWITCH12 N·m(1.2 kgf·m, 9 lbf·ft)CYLINDER LINES15 N·mINLET LINE JOINT14 x 1.5 mm37 N·m(3.8 kgf·m, 27 lbf·ft)PUMP INLET HOSE6 x 1.0 mm11 N·m(1.1 kgf·m, 8 lbf·ft)PUMP OUTLET HOSERETURN HOSECYLINDER LINES15 N·mBARETURN HOSEAARETURN LINE6 x 1.0 mm9,5 N·m(0.97 kgf·m, 7.0 lbf·ft)6 x 1.0 mm9,5 N·m(0.97 kgf·m, 7.0 lbf·ft)B